This Water Pipe Adapter is manufactured by Delta 3D Studios and is designed to fit the PAX 2 and PAX 3 Vaporizer without a mouthpiece. It can also fit over a flared mouthpiece. This adapter is compatible with both 14mm and 18mm female water pipes / bubblers. Using a water pipe adapter and hooking your vaporizer to a bong is the most instantaneous way for you to significantly enhance your vaping experience. You may clean this product with any conventional glass cleaning method, such as with isopropyl alcohol, PBW, and hot water.
PAX 3 to water pipe
For dry flower just warm PAX 3 up on Boost heat setting with adapter in place, leave PAX 3 upright while preheating. Once fully preheated (plus a few extra seconds) turn the PAX 3 upside down with the 14mm male adapter in the water pipe’s 14mm female opening like in the picture. Take your pull through the water pipe then remove the PAX 3 and place it upright again so it heats up properly before repeating the same steps for your next pull.
Quick delivery and good product.
Works, but will I actually use it?
Fits and functions good but Pax 3 doesn’t generate enough vapor, even on boost setting, to fill up a larger water pipe. Recommend using with a smaller water pipe, you may have better luck than me.
Purchased For My Wife
The adapter works great for her, but she is a little disappointed that her PAX 3 doesn’t perform very well with it. The PAX 3 loses it’s temperature to fast and she get’s frustrated and stops using it. The PAX 3 LED display stays green for just a little bit and then turns purple like it is trying to heat back up to temperature. So she ends up not using it very much. Adapter works great, PAX 3 not so great and it is on the highest setting.
Hi Darin, Creating a service ticket for you now to address the issues above. We WILL get this squared away for you. With best regards, Larry
I use it directly bot with a water tool.